
Chapter E? • Detailed Setup
Powering Up Your Desktop Projector and external monitor (if you are using
one) must be powered-up before turning on your computer, so
that your computer properly senses each display during its boot
up sequence.
Appiying Power to the Projector
On the rear connector pane! of the projector, you'll find a power
cord receptacle and an AC POWER switch.
....
......
''"'I
.....
iniD^
■P5
Figure T7
Power receptacle C13, AC POWER switch CS), and circuit
breaker reset switch [33
To power up the projector:
I. Plug the power cord into the Desktop Projector's power
receptacle at the rear of the unit,
CAUTIOISi! Plug the AC power cord into the Desktop
Projeaor BEFORE connecting it to an electrical outlet. If you
plug the power cord into the wail first, it might damage the
projector.
User’s Guide •
Comentarios a estos manuales