Ask-proxima DP9250 Manual de usuario descargar pdf (Pagina 10)

CONNECTING THE PROJECTOR

•

Your projector is equipped with various audioArideo inputs and outputs including Computer HDB15-pin (VGA) term^H

-lonitor HDBI 5-pin (VGA) terminals and S-VHS video . IP

CONNECTING THE COMPUTER

CONNECTING TO THE COMPUTER INPUT HDB15-PIN (VGA) TERMINALS (1 and 2Ì

Personal computers can be connected to the HDB15-pin (VGA) terminai on the projector,

• Connect the computer to these terminais using the VGA cable and VGA/MAC adapter (provided).

WARNING: For projectors, the VGA cable provided is designed to reduce RFI (Radio Frequency Interference

emissions. For reguSatory compliance reasons, this cable must be used and must not be replaced by an

other cable.

CONNECTING TO THE MONITOR OUTPUT HDB15-P1N (VGA) TERMINAL

This terminal contains the information that is viewed on the screen.

An extemaimonitor can be connected to the HDB15-pin (VGA) terminal on the projector.

• Connect the monitor to this termina! using a monitor cable (not provided).

HD815-PIN

TERMINAL

Pin No./Signal

1 Red input 9 Non Connect

5'4 3-2 ^

0 0 0-00

2 Green input

1Q Ground (Vert, syns

3 Blue input 11 Sense 0

10 9-8 7 6."_7

0-0-0 0 o 7

4 Sense 2 12 Sense 1

I o’o b o*.b' 7.

5 Ground (Horiz. sync.) 13 Horiz. sync.

VJ5'1-413t2i1 yt

6 Ground (Red)

14 Vert. sync.

7 Ground (Green)

8- Ground (Blue)

15 Reserved

CONNECTING TO THE COMPUTER AUDIO INPUT JACKS (1 and 2)

• Connect audio outputs from your computer to these jacks using the audio cable (not provided).

CONNECTING TO THE MULTI-POLE 12-PiN (CONTROL PORT) CONNECTORS (1 and 2)

• If you wish to control the computer with projector’s remote control unit, you must connect control port (PS/2, Serial c

ADB port) on your computer to projector’s control port with cable, (three type of cables provided)

CONTROL PORT

PS/2=

,i=*ort

CLK

DATA

GND

Serial

Poii

TxD

RxD

READY

GND

ADBirj:

iPo'rt

ADB

GND

CONTROL PORT CABLE

REMOVAL HINT

Disconnect control port cable

with foilowing steps.

1. Hold the portion (A) of the

connector with one hand,

2. Pull the portion (B) arrow

direction and remove

connector.

iXL

~B.

NOTE: The RxD port (5 pin on the' Serial Port) is provided on control port 2 connector only. If you control the proje^

by computer, you must connect control port 2 connector.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 51 52

Comentarios a estos manuales

Sin comentarios

Ask-proxima DP9250 Manual de usuario Pagina 10

Comentarios a estos manuales

Relacionado con productos y manuales para Proyectores Ask-proxima DP9250